Ningbo, Changzhou electrolytic polishing equipment, door spent electropolishing equipment 
 Main features and performance 
 Electropolishing is thrown workpiece as the anode, insoluble metal as the cathode, the poles at the same time immersed in the electrolytic cell, through DC and selective anodic dissolution of the workpiece surface is gradually leveling so as to achieve the workpiece to increase the surface brightness effect . 

 Current specifications 100A/200A/300A/500A/1000A/1500A/2000A/3000A/5000A/7500A voltage of 12 volts or 15 volts. Can also be customized in accordance with the actual situation of the user. 
 Host a high-frequency rectifier with time, current, voltage, temperature control, swing set and digital display. Contain overheating and short circuit protection device. 
 3, the device pipelined design, very easy operation, greatly improving production efficiency. 
 4, the device configuration pickling tank, electrolyzer, cleaning tank, passivation tank, cleaning tank. 
 5 tank with corrosion 10mm PP material production, environmental compliance. 
 6, provides a full range of technical services, equipment commissioning, technical training and electrolytic polishing. 

 Applicable range of materials: 
 1, stainless steel (martensite, austenite and ferrite) 
 2, aluminum and its alloys 
 3, copper and its alloys 
 4, iron and steel 

 General portfolio includes: 
 Rectifier + slot polishing + anode rod + cathode rod + cathode stereotype + two copper + quartz heater + slurry + electrolytic Rack (add controller + Temperature Controller). 

 Assembly process: 
 1, the two wires: 1. Rectifier 500A wire 4 points AB in two colors A color wire connected rectifier positive and polishing slot anode rod (middle). B color wire is connected to the anode of the rectifier and polished groove cathode rods (both sides). 
 2, the cathode stereotype: the stereotype should hang in the cathode rods (both sides) Note cards tight and tidy. 
 3, quartz heater: on the both sides of the the Cao body head angle. 
 Quartz heater voltage: 220V single power: 2KW and 3KW. 
 Quartz heater must be in place of the slurry can be heated using temperature 40-70. 
 Just heating a good polishing fluid, the upper and lower temperature inconsistencies, use before mixing consistent. 
 4, the slurry: slurry to enter the polishing tank is heated to 50-65 degrees best new polishing solution is not stable, it is recommended that the electrolytic materials aging, aging time of 5 hours or more, and then put into production. 
 Other products; Rust of Rust of steel Series MH-101 MH-102 MH-103 degreasing rust rust inhibitor of the combo the MH-104 MH-105 at room temperature blackening agent MH-106 iron and steel chemical polishing machine stainless steel ; MH cleaning agent MH-201-202 chemical polishing solution of passivating agent at room temperature MH-203 MH-204 electrolytic polishing liquid copper series; the MH-301 with the chemical polish of bronze agent MH-302 MH-303 electrolytic polishing machine MH-304 acid degreasing agent MH-305 copper antioxidants aluminum series; and MH-401 aluminum degreasing agent MH-402 Pickling MH-403 chemical polishing machine MH-404 electrolytic polishing solution 
 Special note: more than one device offer without electropolishing solution machine problems, and warranty repair for one year welcome new and old customers advice